xinjia_06Mon - Sat : 8:30AM - 5:30 PM Closed in Sundays
xinjia_10Xiwangzhuang Industrial Zone,Anping County,Hebei,P.R.China.
You are here: Home » News » Knowledge » How to Make Powder Coated Wire Mesh

How to Make Powder Coated Wire Mesh

Views: 4     Author: Site Editor     Publish Time: 2017-04-10      Origin: Site

Powder coating is a process of creating a solvent-free covering on an item. In contrast to spray paints, the powder coat is a volatile organic compound (VOC) that is fume free and usually more durable. Applying the coating to wire mesh material takes a special sprayer and the ability to heat the mesh evenly. Powder coating materials can be found at a variety of online and local home improvement stores.

Welded Wire MeshCrimped Wire Mesh can be coated by Powder


1.Lay out the mesh as flat as possible.

2.Apply a generous amount of isopropyl alcohol to a clean cloth. Wipe the mesh thoroughly.

3.Screw or snap the can of powder coating into the Corona sprayer device. Plug the gun into AC power using the supplied transformer.

4.Spray the mesh with the powder, holding the sprayer 6 to 8 inches over the surface of the mesh.

5.Place the mesh into the convection oven heated to 390 to 400 degrees Fahrenheit.

6.Monitor the powder covered mesh. Once the powder melts evenly over the surface, turn off the oven.

7.Put on the oven mitts and remove the mesh. Allow it to cool thoroughly.




Xinjia Metal Products Co., Ltd. is located in Anping, the famous Wire Mesh Land of China. Started since 1995, Xinjia Metal Products Co., Ltd. 


Tel: +86-318-7977166 
Fax: +86-318-7977166
Add: Xiwangzhuang Industrial Zone,Anping County,Hebei,P.R.China 053600
Copyright © 2017 Anping Xinjia Metal Products Co.,Ltd. All rights reserved .      冀ICP备17024718号-1         Design by [Rongchuangmedia]